： 53343323
TOC總有機碳試驗儀用于測試純水、制藥工業去離子水和注射用水的有機碳含量制藥和生物化學清洗驗證：在制藥和生物化學制藥業處理過程中，監測在循環清洗。半導體中監測純化水中toc的含量。
一、工作原理
本儀器采用紫外氧化的原理，將樣品中的有機物氧化為二氧化碳，二氧化碳的測試采用的是直接電導率法，通過測試經過氧化反應的樣品的總碳含量和未經過氧化反應的樣品總無機碳的含量差值來測定總有機碳含量，即：總有機碳（TOC）=總碳（TC）-總無機碳（TIC）。
二.產品特點
1.儀器采用便攜設計，使用輕便，方便移動至取樣點。
2.采用嵌入式系統，觸摸屏設計，純中文操作方便簡易。
3.針對制藥用水（TOC含量在1000ppb以下）總有機碳含量的檢測設計，進行檢測。
4.配備大量的儲存空間，能夠存儲大量的測試數據。
5.中文打印，輸出測試參數、測試結果。
6.在使用、貯存和更換過程中不需要氣體或試劑，無移動部件，減少維修和維護成本。
7.當測試樣品濃度超過規定限度，儀器能夠自動報警，并輸出控制信號。
8.符合國家2010版《中國藥典》規定的測試方案，可以提供 IQ/OQ/PQ 服務。
三、性能規格:
測量范圍：0.001mg/L～1.000 mg/L
精 度：±4% 測試范圍
分 辨 率：0.001mg /L
分析時間：連續分析
響應時間：6分鐘之內
檢測極限：0.001mg /L
樣品溫度：1- 90℃
重復性誤差：≤ 3%
電源要求/功能：220V
顯 示 屏：彩色觸摸屏
四、應用范圍
1. 該儀器可用于檢測制藥工業中純化水、注射用水和去離子水中有機碳的濃
度；也可用于半導體行業中超純水TOC的檢測。
2. 在制藥領域和生物化學領域清潔驗證過程中，可用于驗證清潔效果。
3. 該儀器具有在線檢測功能，可以在線監測制藥工業的制水系統、半導體工業
的超純水制備系統和晶片工藝過程、電廠去離子水制備過程等。
五、技術參數：
編號 | 項目 | 參數 |
01 | 電 源 | AC220V±22V |
02 | 頻率 | 50HZ±1HZ |
03 | 功率 | 95W |
04 | 外形尺寸 | 340*390*145mm |
05 | 重量 | 15kg |
06 | TOC檢測范圍 | 0.001mg/l-1.0mg/l |
07 | 檢測精度 | ±5% |
08 | 檢測時間 | ≤4min/次 |
09 | 響應時間： | ≤15min |
10 | 樣品流量 | 0.5ml/min |
11 | 樣品溫度 | 1-95℃ |
12 | 環境濕度 | ≤85%RH |
13 | 環境溫度 | 10-40℃ |
14 | 重復誤差 | ≤3% |
15 | 線性誤差 | ±5% |
TOC tester used for testing the water, pharmaceutical industry, the organic carbon content of deionized water and water for injection of pharmaceutical and biological chemical cleaning validation: in the pharmaceutical and biological chemical industry in the process, monitoring the cleaning cycles. The content of toc monitoring in the semiconductor purified water.
A, work principle
The instrument adopts the principle of ultraviolet oxidation, organic matter in the sample of the oxidation of carbon dioxide, carbon dioxide test USES a direct conductivity method, pass the test after the sample of the oxidation reaction of total carbon content and without the sample of the peroxidation of total inorganic carbon content difference to determination of total organic carbon content, i.e., the total organic carbon (TOC) = total carbon (TC) - total inorganic carbon (TIC).
2. Product features
1. The instrument USES a portable design, the use of lightweight, convenient to move to sampling points.
2. Adopt the embedded system, touch screen design, pure Chinese simple easy to operate.
3. In view of the pharmaceutical water (TOC content under 1000 PPB) total organic carbon content detection is designed, tested.
4. Equipped with a lot of storage space, can save a lot of testing data.
5. Chinese print output test parameters, test results.
6. In the process of use, storage and replace don't need gas or reagent, no moving parts, less maintenance and maintenance costs.
7. When the test sample concentrations in excess of the prescribed limit, the instrument can automatically alarm, and output control signals.
8. In conformity with the 2010 edition of "Chinese pharmacopoeia" provisions of the state of the testing solution, can provide the IQ/OQ/PQ service.
Three, performance specifications:
Measuring range: 0.001 mg/L ~ 1.000 mg/L
Pure c: plus or minus 4% test range
Resolution: 0.001 mg/L
Analysis time: continuous analysis
Response time: 6 minutes
Detection limit: 0.001 mg/L
The sample temperature: 1-90 ℃
Repeatability error: 3% or less
Power requirements/function: 220 v
Show panel: color touch screen
Four, scope of application
1. The instrument can be used to detect the pharmaceutical industry in the purified water, water for injection and organic carbon concentration in deionized water
Degree; Can also be used in the detection of ultrapure water TOC in the semiconductor industry.
2. In the field of pharmaceutical and biological chemistry cleaning validation process, can be used to verify the cleaning effect.
3. The instrument has the function of on-line detection, can online monitoring system of pharmaceutical industry water system, the semiconductor industry
The preparation of the system and wafer process, the preparation process of deionized water of power plants.
售后服務：
1、設備保修兩年，終身服務，兩年內非人為損壞的零部件免費更換，保修期內接到用戶邀請后， zui遲響應時間為2小時內，在與用戶確認故障后，我公司會在48小時內派工程師到達現場進行免費服務，盡快查清故障所在位置和故障原因，并向用戶及時報告故障的原因和排除辦法 。
2、保修期內人為損壞的零部件按采購（加工）價格收費更換。
3、保修期外繼續為用戶提供優質技術服務，在接到用戶維修邀請后3天內派工程師到達用戶現場進行維修。并享有優惠購買零配件的待遇。
4、傳感器過載及整機電路超壓損壞不在保修范圍內。
