污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
蘇州市宏瑞源科技股份有限公司
蘇州市宏瑞源科技股份有限公司
美國ATI公司的TDA-5C氣溶膠發生器能產生*的多種直徑分布的氣溶膠粒子，與TDA-2I等光度計配合使用時能提供足夠的挑戰粒子去測量高效過濾系統（流量范圍從1.500-65,000立方英尺/分鐘） 。
氣溶膠發生器 TDA-5C
美國ATI公司的TDA-5C氣溶膠發生器能產生*的多種直徑分布的氣溶膠粒子，與TDA-2I等光度計配合使用時能提供足夠的挑戰粒子去測量高效過濾系統（流量范圍從1.500-65,000立方英尺/分鐘） 。 TDA-5C氣溶膠發生器的油路保險供應系統和熱切換功能是目前zui安全的氣溶膠發生器。這是一款為用戶提供更加方便的增強型氣溶膠發生器。操作簡單、穩定性能好，適用于認證，HEPA性能試驗和安裝。需采用惰性氣體，適用于AC220v±10%50HZ電源
典型應用：
制藥行業（潔凈房, 層流臺, 生物安全柜, 手套箱, HEPA吸塵機, HVAC系統, HEPA過濾器, ULPA過濾器, 負壓過濾裝置, 手術室, 核子過濾系統, 匯集保護過器）過濾器的檢漏
技術參數：
可使用的流量范圍 | 1,500-65,000cfm(42-1,839.5m3/min) |
發生濃度 | 10ug/L： 流量65,000cfm(約1,839.5m3/min時) |
100ug/L：流量6.500cfm(約183.95 m3/min時) | |
發生粒子 | PAO、DOP、多分散 |
發生方法 | 加熱發生 |
壓縮氣體(惰性) | Nitrogen,Argon,Carbon Dioxide或Helium (50psi)) |
電源 | AC220v±10%50HZ |
外形尺寸 | 約380×250×250mm |
重量 | 約9.1kg |
適用20psi（0.14Mpa）的壓力時 注：不建議采用DOP
5C Aerosol Generator
Printable Specification Sheet
Description
The 5C Aerosol Generator has been designed to provide operator convenience and improved performance. The 5C is ideal for certifying or testing HEPA filters or installations with air flows from 1,500 to 65,000 cfm. It requires an inert gas source and 115/230 volts @ 750 watts electrical service.
5C Features
The 5C has all controls and displays grouped on the front panel away from the aerosol generator output nozzle. The unit has a large aerosol liquid capacity for operation up to 4 hours at full output without refilling. In addition, its digital temperature control allows the operator to set the unit for optimum conditions for the specific aerosol agent being used.
The 5C is capable of generating a wide variety of aerosol concentrations by discharging a controlled quantity of oil into a large heated area. The liquid is vaporized and condensed into a polydispersed aerosol while in the presence of a small amount of nitrogen delivered at approximay five pounds of pressure. The efficiency at which the aerosol is produced enables the 5C Generator, when used in conjunction with Analog or Digital photometers, to provide enough aerosol to leak test filtration systems from 1,500 to 65,0000 cfm. Systems larger than 6,500 cfm may be tested for leaks at less than 100 micrograms per liter when the photometer sensitivity is increased.
5C Specifications
Aerosol Output Range: 1,500-65,000 cfm
Aerosol Concentration 100 ug/1@*: 6,500 cfm
Aerosol Concentration 10 ug/1@*: 65,000 cfm
Generator Type: Vapor Condensation
Compressed Air: Not Required
Compressed Gas: Nitrogen, Argon, Carbon Dioxide or Helium (*20 cfh @ 50 psi)
Aerosol Type: Polydispersed (Cold)
Size: 15" L × 9" W × 10" H
(38cm L × 23cm W × 25cm H)
Weight-Pounds (lbs): 23 lbs.
Weight-Kilograms (kg): 10.4 kg
Electrical: 115 VAC / 60 Hz or 230 VAC / 50hz
Compliance:
EN61000-6-2:2005 |
EN61000-6-4:2007 |
EN61010-1:2001 |
UL61010-1:2004 |
FCC Part 15 (7/2008) Class A |
ICES-003 (CAN/CSA-CEI/IEC 22:02) |
* For high volume output, more uniform particle size, and safety, the liquid is aerosolized, superheated to vapor then recondensed by ambient air into a cold poly-dispersed aerosol. The propellant must be an inert gas since the liquid vapor temperature is above the liquid flashpoint.
Please note:
ATI does not recommend the 5C for certification of Biological Safety Cabinets (BSC's). Typical BSC flowrates are beneath the level at which a 5C is capable of providing a consistent and stable aerosol output.
NSF/ANSI 49-2002 Annex F, specifies the use of a Laskin nozzle generator or equivalent during certification.
For purposes of this NSF Standard's requirements, the 5C generator is not considered a Laskin nozzle equivalent aerosol generator.
Applications
Industries
關鍵詞：塵埃粒子計數，懸浮粒子測試儀，顆粒分析，空氣粒子，儀器儀表，凈化工程，凈化車間，凈化設備，潔凈車間，制藥車間，制藥機械，制藥工程，浮游細菌采樣器，風量儀，生物安全柜，凈化工作臺，潔凈工作臺，生物工程，生物器材，烘箱，培養箱，干燥箱，實驗室設備，實驗室工程，檢測儀器，氣溶膠發生器，氣溶膠光度計，懸浮粒子發生器，懸浮粒子光度計，溫濕度壓差，記錄儀，潔凈采樣車，傳遞窗，壓差計，測振儀，輻照計，微生物檢測，工程公司，凈化公司，制藥公司，生物公司，風淋室，貨淋室，稱量室，通風柜
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
環保在線 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
